Mars Hydro FC 8000-EVO 800W Commercial LED Grow Light | 2.9 μmol/j

Precision Control in Any Space

Every facility running inconsistent equipment pays a tax it never sees on the invoice. Lamp depreciation curves that nobody tracks, manual dimming schedules that drift between operators, and canopy hot spots that produce uneven density across a single bench — these are not equipment failures, they are system failures. When the light source cannot hold a repeatable output, every other variable in the grow protocol becomes suspect. Nutrient schedules calibrated against a degrading light source produce results that cannot be replicated. The cost is not just one cycle — it compounds across every run until the root cause is identified and corrected.

After deployment, the operational picture changes materially. A 5×5 ft canopy receives uniform photon distribution from a passively cooled bar array that holds output without active thermal management or scheduled lamp swaps. Dimming is dialed in once per growth stage and held there — no manual drift, no operator-to-operator variance. The fixture runs continuously without the maintenance interruptions that compress productive canopy time. Scheduling becomes predictable, yield data becomes comparable across cycles, and the facility can scale additional units into the same control architecture without rebuilding the lighting infrastructure.

The mechanism behind that outcome is a six-bar array of Samsung LM301H EVO diodes — the same diode platform used in premium-tier commercial fixtures — operating at a system-level efficacy of 2.9 µmol/j. Each diode is rated at 3.14 µmol/j, and the full-spectrum output spans 660–665 nm red, 2800–3000K warm white, and 4800–5000K cool white channels, covering the complete photosynthetically active range from vegetative establishment through peak flower. The fixture draws 800W±5% at AC220–277V (or 800W minus 1–10% at AC100–120V) and delivers 2320 µmol/s PPF across the 5×5 ft canopy footprint. Dimming is fully adjustable, and the iConnect daisy-chain architecture allows multiple units to be managed from a single control point as the facility scales. In practical terms, the FC 8000-EVO delivers 2320 µmol/s PPF across a 5×5 ft canopy at 800W draw with passive thermal management and no consumable lamp components.

Where This Belongs (and Doesn't)

Electrical installation must comply with local codes. Circuits must be rated for continuous load at the amperage values specified below. HVAC load calculations should account for 2728 BTU/hr of thermal output per fixture. Consult a licensed electrician before installation.

How It Works

The FC 8000-EVO is built on a six-bar passive-cooling architecture. Heat generated at the diode level is conducted through the bar housings and dissipated across the fixture surface area without fans, pumps, or any active thermal component. This eliminates the failure modes associated with fan-cooled fixtures — bearing wear, dust accumulation in moving parts, and noise — while keeping the thermal envelope predictable for HVAC load planning. The fixture produces 2728 BTU/hr of thermal output, a fixed value that does not increase with lamp age because there is no lamp degradation curve. LED output is governed by diode physics, not combustion chemistry.

The diode array uses Samsung LM301H EVO chips rated at 3.14 µmol/j per diode. At the system level, the fixture achieves 2.9 µmol/j PPE — a figure that reflects real-world driver losses and thermal operating conditions, not peak-bin laboratory values. The spectral output covers three channels: 660–665 nm deep red for photosynthetic peak absorption, 2800–3000K warm white for broad-spectrum vegetative and transitional-phase support, and 4800–5000K cool white for blue-channel vegetative development and structural growth. All three channels operate simultaneously across the full 2320 µmol/s PPF output, with no channel switching or programmable spectrum adjustment required. Dimming is continuous and adjustable, allowing intensity to be set per growth stage without altering spectral ratios.

Control architecture is built around the iConnect system, which allows multiple FC 8000-EVO units to be daisy-chained and managed from a single dimming controller. This is the scaling mechanism that makes the fixture relevant beyond single-room deployments — a facility adding benches adds fixtures to the existing control chain rather than building a parallel control infrastructure. Input voltage is universal at AC100–277V, with amperage draw of 6.635A at AC120V, 3.266A at AC240V, and 2.847A at AC277V. The foldable bar design allows the fixture to be shipped and stored compactly, then deployed flat for uniform canopy coverage. In practical terms, the FC 8000-EVO delivers 2320 µmol/s PPF across a 5×5 ft canopy at 2.9 µmol/j with 2728 BTU/hr thermal output and passive cooling requiring no maintenance intervention.

Commercial Assurance

• Warranty: Up to 5-Year Warranty as specified by Mars Hydro. "Up to" indicates the maximum coverage period; review full warranty terms at point of registration.
• Lifetime Customer Support: Mars Hydro provides lifetime customer support independent of the warranty period.
• Certifications: ETL, CE, UKCA, RoHS — fixture meets the electrical safety and compliance standards required for licensed commercial facility deployment across the United States.
• Diode Platform: Samsung LM301H EVO — the same diode generation used in premium-tier commercial fixtures, verified by manufacturer specification.
• Authorized Source: Cannafull Spectrum Solutions is a factory-authorized dealer. Warranty coverage is valid only on units purchased through authorized channels. Gray-market units are not eligible for manufacturer warranty service.

System Integration

• iConnect Daisy Chain: Multiple FC 8000-EVO units connect through the iConnect system for centralized dimming control — one controller manages the full fixture chain without additional hardware per unit.
• Universal Voltage Compatibility: AC100–277V input accepts both 120V and 240V/277V facility wiring, eliminating voltage-matching requirements during facility buildout or expansion.
• Passive Thermal Profile: No active cooling components means the fixture integrates into existing HVAC load calculations as a fixed 2728 BTU/hr heat source with no variable thermal output over the fixture lifespan.
• Foldable Bar Design: The six-bar foldable form factor reduces shipping volume and allows single-operator installation without rigging equipment, lowering deployment labor cost per unit.
• Scalable Deployment: The iConnect architecture and universal voltage input are designed for facilities adding capacity incrementally — each new unit integrates into the existing control and electrical infrastructure without system redesign.

Facility Integration Data

The following ROI reference data is based on published specifications: 800W draw per fixture, 2.9 µmol/j PPE, 5×5 ft canopy coverage, and a manufacturer-stated maximum yield of 3.5 g/W. Electricity cost modeled at $0.12/kWh. Figures are reference estimates; actual results depend on facility-specific variables including strain, cultivation protocol, and environmental management.

Yield figures derived from manufacturer-stated 3.5 g/W maximum at 800W per unit. Power cost calculated at $0.12/kWh over 18-hour photoperiod, 30 days. Reference estimates only — not a yield guarantee.

Operator Field Notes

• Voltage Selection Matters: At AC120V, the fixture draws 6.635A — verify circuit capacity before installation. Running at AC240V (3.266A) or AC277V (2.847A) reduces per-circuit amperage load and is preferred for multi-fixture deployments on shared circuits.
• Dimming Protocol: Set intensity per growth stage at initial deployment and document the setting. The iConnect system holds the programmed level; operator-to-operator variance is eliminated once the schedule is locked in.
• Thermal Planning: Budget 2728 BTU/hr per fixture in HVAC load calculations. Passive cooling means the thermal output is constant and predictable — no variance from fan failure or airflow obstruction.
• Daisy Chain Limit: Confirm the maximum number of units per iConnect chain with Mars Hydro technical support before deploying multi-fixture runs. Exceeding the rated chain length can affect dimming accuracy across the array.
• Foldable Bar Deployment: Ensure all six bars are fully extended and locked flat before powering the fixture. Partially folded bars concentrate heat and reduce canopy coverage uniformity.
• Warranty Registration: Register the unit with Mars Hydro immediately after installation to activate the up-to-5-year warranty. Unregistered units may be subject to reduced coverage terms.

Operator FAQ

Shipping & Logistics

• Shipping Territory: Cannafull Spectrum Solutions ships within the contiguous 48 United States only. Orders to Alaska, Hawaii, U.S. territories, or international addresses cannot be fulfilled through this channel.
• Free Shipping: Complimentary ground shipping on qualifying orders over $49 to contiguous U.S. addresses. Freight class and carrier selection are at Cannafull Spectrum Solutions' discretion for large or multi-unit orders.
• Returns: Returns are accepted subject to Mars Hydro and Cannafull Spectrum Solutions return policy terms. Defective units are handled under warranty protocol. Non-defective returns must be initiated within the return window specified at cannafullspec.com/pages/return-policy.
• Restocking Fee: Returns of non-defective items are subject to a restocking fee of up to 25% per our Return Policy. Review full terms at cannafullspec.com/pages/return-policy before ordering.

Questions about your order or a multi-unit deployment quote? Contact Cannafull Spectrum Solutions directly at cannafullspec.com or through the store contact page.

What's in the Box

• 1× Mars Hydro FC 8000-EVO 800W LED Grow Light (6-bar foldable assembly)
• Power cord (configuration subject to destination voltage; confirm at order)
• Hanging hardware (ratchet hangers or equivalent — confirm included accessories with current shipment manifest)
• iConnect controller cable for daisy-chain dimming integration
• User manual / quick-start documentation

Note: Box contents are based on standard Mars Hydro FC 8000-EVO packaging as described in available product documentation. Cannafull Spectrum Solutions cannot guarantee inclusion of specific accessories not confirmed in the current manufacturer shipment manifest. Contact us before purchase if specific accessory inclusion is a requirement for your deployment.

Regional Compliance & Deployment Notes

• U.S. Electrical Compliance: ETL listing satisfies the primary U.S. electrical safety standard for commercial facility deployment. Verify acceptance with your local AHJ prior to installation in licensed cultivation facilities.
• State Licensing Compatibility: The FC 8000-EVO carries no state-specific cultivation license restrictions. Operators are responsible for ensuring their facility's lighting infrastructure complies with state cannabis cultivation regulations, canopy measurement rules, and any wattage-per-square-foot limitations imposed by their licensing authority.
• RoHS Compliance: The fixture meets RoHS hazardous substance restrictions, relevant for facilities subject to environmental compliance audits or waste disposal regulations governing electronic equipment.
• Shipping Jurisdiction: Available for deployment across licensed U.S. facilities in the contiguous 48 states. Cannafull Spectrum Solutions does not ship to Canadian provinces or international addresses.
• Circuit and Load Compliance: Installation must comply with NEC (National Electrical Code) requirements for continuous loads. At AC120V, the 6.635A draw requires a circuit rated for at least 8.3A continuous (NEC 80% rule). At AC240V, the 3.266A draw requires a circuit rated for at least 4.1A continuous. Consult a licensed electrician for all installation work.