Alien 水培罐连接器 直型 40 毫米

Quick Spec: Connector Size: 40mm | Connector Type: Straight | Compatibility: V-SYSTEM | SKU: BD101-0036 | Price: $15.90 USD

Precision Control in Any Space

Every leak point in a reservoir circuit is a decision you didn't make — it was made for you by a fitting that was never designed for the system it was installed in. Mismatched connectors create slow drips that go unnoticed until nutrient solution has pooled beneath a reservoir, flow rates have drifted from target, and the operator is troubleshooting a problem that should never have existed. The cost is not just the lost solution — it is the time spent diagnosing, the variance introduced into the feed schedule, and the compounding uncertainty that follows every irrigation cycle when the hardware cannot be trusted.

After a correct installation with a properly spec'd connector, the reservoir circuit disappears from the operator's attention entirely. Flow moves from tank to canopy on schedule, drain-to-waste volumes are predictable, and the irrigation system behaves as a controlled input rather than a variable. The operator's focus returns to the crop — not to the plumbing.

The Tank Connector Straight 40mm achieves this by matching the dimensional and compatibility requirements of the V-SYSTEM platform directly. The 40mm straight-profile specification is not a nominal approximation — it is the connector geometry the V-SYSTEM reservoir architecture is designed to accept, ensuring a seated, leak-resistant interface without modification, shimming, or thread adaptation. Compatibility with V-SYSTEM is a confirmed manufacturer specification, not an inferred fit. In practical terms, the Tank Connector Straight 40mm delivers a sealed 40mm straight connection point within V-SYSTEM reservoir assemblies at a per-unit cost of $15.90 USD.

Where This Belongs (and Doesn't)

This connector is a mechanical irrigation fitting. It is not an electrical component and does not interface with HVAC, environmental control, or any powered system. Installation should follow V-SYSTEM assembly documentation. If you are unsure whether this connector is the correct specification for your reservoir configuration, contact Cannafull Spectrum Solutions before ordering.

How It Works

The Tank Connector Straight 40mm functions as the interface point between the V-SYSTEM reservoir tank wall and the irrigation line that carries nutrient solution to the canopy. The straight connector profile seats flush against the tank wall aperture, creating a sealed passage that maintains flow direction without introducing angular stress on the fitting or the tank material. The 40mm connector size corresponds directly to the port geometry specified in V-SYSTEM tank assemblies, which means the fitting engages the designed seating surface rather than relying on compression against an oversized or undersized opening.

In a drain-to-waste configuration, the connector establishes the exit point through which spent nutrient solution leaves the reservoir after each irrigation cycle. In a top-feed recirculating setup, it serves as the supply or return port depending on system layout. In both cases, the integrity of the connection at the tank wall determines whether the irrigation circuit behaves as a closed, controlled system or as a source of uncontrolled loss. A correctly seated 40mm straight connector eliminates the fitting as a variable in the irrigation equation. In practical terms, the Tank Connector Straight 40mm provides a manufacturer-specified 40mm straight-profile connection point within V-SYSTEM reservoir assemblies, removing the tank wall interface as a source of flow variance or nutrient loss.

Commercial Assurance

System Integration

• Designed for direct integration with Alien Hydroponics V-SYSTEM reservoir tanks — no modification or adapter required when installed in the correct 40mm port.
• Compatible with both top-feed and drain-to-waste irrigation configurations within the V-SYSTEM platform.
• Straight connector profile maintains inline flow direction, reducing turbulence and pressure drop at the tank wall interface.
• Functions as a replacement component in existing V-SYSTEM installations where the original connector has degraded or been damaged.
• Pairs with other V-SYSTEM fittings, tubing, and reservoir hardware available through Cannafull Spectrum Solutions for complete system builds or targeted repairs.

Facility Integration Data

The following table provides per-unit and fleet-level cost reference for operators sourcing Tank Connector Straight 40mm units across single-site or multi-site V-SYSTEM installations.

Operator Field Note

• Verify the tank port diameter is 40mm before installation. The connector size is a hard specification — forcing a mismatched fitting will compromise the seal and potentially damage the reservoir wall.
• Inspect the seating surface on the tank wall for debris, residue, or deformation before installing a new connector. A clean, undamaged seating surface is required for a leak-free interface.
• In drain-to-waste configurations, confirm the connector orientation supports the intended flow direction before finalizing the installation. Straight connectors do not redirect flow — line routing must account for this.
• Keep a minimum of two spare connectors per reservoir bank in standing inventory. Connector failure during an active irrigation cycle requires immediate replacement to prevent uncontrolled nutrient loss.
• When building a new V-SYSTEM installation, install and pressure-test all tank connectors before filling reservoirs with nutrient solution. Testing with plain water first isolates fitting integrity from nutrient management variables.
• Document connector installation dates per reservoir. Scheduled inspection intervals reduce the probability of undetected degradation in high-cycle irrigation environments.

Operator FAQ

Shipping & Logistics

• Shipping Territory: Cannafull Spectrum Solutions ships within the contiguous 48 United States only. Orders outside this territory cannot be fulfilled.
• Fulfillment: Orders are processed and shipped from our fulfillment location. Estimated transit times will be provided at checkout based on destination. Local pickup may be available at the Longmont location — contact us to confirm availability before selecting this option.
• Returns: Returns are accepted subject to Cannafull Spectrum Solutions return policy terms. Items must be in original, uninstalled condition to qualify. Contact cannafullspec.com to initiate a return authorization before shipping any product back.
• Restocking Fee: Returns of non-defective items are subject to a restocking fee of up to 25% per our Return Policy. Review full terms at cannafullspec.com/pages/return-policy before ordering.

Questions about your order? Contact Cannafull Spectrum Solutions at cannafullspec.com.

What's in the Box

• 1x Alien Hydroponics Tank Connector Straight 40mm (SKU: BD101-0036)

Note: Box contents are confirmed based on available source data for SKU BD101-0036. Installation hardware, sealant, and assembly documentation are not confirmed as included. If your application requires specific ancillary components, verify inclusion with Cannafull Spectrum Solutions before ordering. Do not discard packaging until installation is confirmed complete and the fitting has been tested under operating conditions.

Regional Compliance & Deployment Notes

• The Tank Connector Straight 40mm is a mechanical irrigation fitting. It is not subject to electrical, photobiological, or emissions compliance standards.
• Operators in licensed cultivation facilities should confirm that all irrigation system components, including tank connectors, are installed in accordance with applicable state and local plumbing, facility, and cultivation license requirements.
• This product is sold for use in lawful cultivation operations within the contiguous 48 United States. Cannafull Spectrum Solutions does not ship to addresses outside this territory.
• No state-specific registration, certification, or compliance documentation is required for this component type under currently available source data. Operators are responsible for confirming local requirements applicable to their specific facility and license type.
• V-SYSTEM platform components should be installed per Alien Hydroponics assembly documentation to maintain system integrity and any applicable manufacturer warranty coverage.

Compliance requirements for cultivation facilities vary by state and license type. The information provided here reflects general applicability based on available product data. Cannafull Spectrum Solutions does not provide legal or regulatory compliance advice. Operators are responsible for confirming all applicable requirements with their state regulatory authority and legal counsel prior to installation and operation.