Bomba de agua Vortex V-SYSTEM de Alien Hydroponics, 180 W, 120 V, 10 800 l/h

Quick Spec: Vortex Water Pump  |  180W  |  120V  |  10,800 l/h flow rate  |  SKU: BD101-5002

Precision Control in Any Space

Every irrigation system is only as reliable as the pump driving it — and when that pump delivers inconsistent pressure, the entire feed schedule becomes a variable you cannot control. Flow that surges and drops between cycles creates uneven saturation across your reservoir, introduces dry zones in top-feed arrays, and forces manual intervention that compounds over time into measurable yield inconsistency. The enemy is not complexity; it is equipment that cannot hold its output steady, turning every irrigation event into a guessing exercise rather than a repeatable operational step.

After deploying a pump that actually holds its rated output, the irrigation system stops being a source of daily uncertainty. Reservoir levels stabilize on schedule. Top-feed lines deliver the same volume to every site, every cycle. Drain-to-waste timing becomes predictable enough to automate without manual correction. The operator's attention shifts from troubleshooting flow problems to refining the feed program itself — which is where the real performance gains are made.

The V-SYSTEM Vortex Water Pump achieves that stability through a 180W vortex pump architecture operating on a standard 120V supply, producing a rated flow rate of 10,800 l/h — a volume sufficient to drive high-demand recirculating reservoirs, multi-site top-feed manifolds, and drain-to-waste systems without the pressure drop that plagues lower-rated equipment. The vortex pump design maintains flow consistency across varying head heights, reducing the performance degradation that occurs when pumps are asked to push volume against elevation or resistance in real installation conditions. In practical terms, the V-SYSTEM Vortex Pump delivers 10,800 l/h of sustained flow on a 180W, 120V draw, making it a direct-swap upgrade for any irrigation circuit where flow consistency is the limiting variable.

Where This Belongs (and Doesn't)

Electrical installation must comply with local codes. Confirm that your circuit can support a continuous 180W load on a 120V supply before installation. Consult a licensed electrician if circuit capacity or GFCI requirements are uncertain. This pump is rated for water-based hydroponic solutions; do not use with flammable or corrosive liquids.

How It Works

The V-SYSTEM Vortex Water Pump operates on a vortex impeller design, which differentiates it from standard centrifugal submersible pumps in one operationally significant way: the impeller does not make direct contact with the primary flow path. Instead, it generates a rotating vortex within the pump chamber that draws fluid through without the impeller sitting in the direct stream. This architecture reduces the risk of flow restriction from minor particulate content in nutrient solutions and maintains more consistent output pressure as head height increases — a common real-world condition in stacked or elevated reservoir configurations.

At 180W on a 120V supply, the pump produces a rated flow of 10,800 l/h. That figure represents the pump's output under rated conditions and is the baseline against which your system's actual head loss — the pressure reduction caused by pipe length, elevation, fittings, and manifold resistance — must be calculated to determine effective delivery volume at the point of use. For most craft-scale top-feed and drain-to-waste configurations, the 10,800 l/h rating provides sufficient overhead to absorb real-world head loss and still deliver high-volume flow to every feed site simultaneously.

The 120V operating voltage means the pump integrates directly into standard North American electrical infrastructure without requiring dedicated high-voltage circuits or phase conversion. A single standard outlet circuit, confirmed to support a continuous 180W load, is the only electrical prerequisite. In practical terms, the V-SYSTEM Vortex Pump delivers 10,800 l/h rated flow at 180W on a 120V supply, with a vortex impeller design that sustains output consistency across the head-height variation typical of multi-tier and elevated reservoir installations.

System Integration

• Reservoir Compatibility: Sized for high-volume recirculating reservoirs; confirm reservoir capacity and turnover rate targets before specifying pump placement and plumbing diameter.
• Top-Feed Manifold Design: At 10,800 l/h, the pump supports multi-site top-feed manifolds; balance manifold line sizing to distribute flow evenly across all feed sites and prevent pressure bias toward shorter runs.
• Drain-to-Waste Scheduling: Consistent rated output enables reliable timed-cycle irrigation; pair with a quality timer or controller to lock in repeatable feed-and-drain intervals.
• Electrical Circuit: Confirm the supply circuit is rated for a continuous 180W load on 120V; install on a GFCI-protected outlet per applicable electrical code for wet-area pump applications.
• Plumbing Interface: Verify outlet fitting diameter against your existing irrigation plumbing before installation; adapters may be required depending on manifold specification.

Facility Integration Data

The table below provides a fleet-scale view of electrical load and unit investment for operators specifying the V-SYSTEM Vortex Pump across multiple irrigation circuits or facilities.

Operator Field Notes

• Head Loss Planning: The 10,800 l/h rating is measured at zero head. Calculate your system's actual head loss — accounting for pipe run length, elevation, fittings, and manifold resistance — to determine effective delivery volume at the point of use before finalizing pump selection.
• Continuous Load Derating: At 180W, this pump qualifies as a continuous load under NEC guidelines. Size your circuit breaker and wiring to 125% of the rated load (225W equivalent) per code requirements for continuous-duty equipment.
• Submersible Placement: Position the pump at the lowest point of the reservoir to ensure the intake remains submerged at minimum reservoir levels; running the pump dry will damage the impeller and void warranty coverage.
• Nutrient Solution Compatibility: Vortex pump design tolerates minor particulate content better than direct-contact centrifugal designs, but the pump is not rated for solutions with heavy sediment. Filter intake water where particulate load is a concern.
• Dimensions and Weight: Physical dimensions and unit weight are not specified in available source data. Contact Cannafull Spectrum Solutions to confirm unit dimensions before specifying installation space or shipping logistics for large orders.
• Local Pickup: This unit is available for in-person pickup at the Longmont location. Contact Cannafull Spectrum Solutions to arrange pickup and confirm availability before traveling.

Operator FAQ

Shipping & Logistics

• Shipping Territory: Cannafull Spectrum Solutions ships within the contiguous 48 United States only. Orders outside this territory cannot be fulfilled through this channel.
• Local Pickup: This unit is available for in-person pickup at the Longmont location. Contact us in advance to confirm availability and arrange pickup timing.
• Returns: Returns are subject to the Cannafull Spectrum Solutions Return Policy. Contact support before initiating any return to receive authorization and instructions.
• Restocking Fee: Returns of non-defective items are subject to a restocking fee of up to 25% per our Return Policy. Review full terms at cannafullspec.com/pages/return-policy before ordering.

Contact Cannafull Spectrum Solutions: support@cannafullspec.com | cannafullspec.com

What's in the Box

• 1x V-SYSTEM Vortex Water Pump 180W 120V (SKU: BD101-5002)

Box contents are based on available manufacturer source data. Accessory items such as fittings, tubing, or mounting hardware are not confirmed in source documentation. Contact Cannafull Spectrum Solutions or the manufacturer to verify complete box contents before purchase if specific accessories are required for your installation.

Regional Compliance & Deployment Notes

• Electrical Code: Installation must comply with the National Electrical Code (NEC) and all applicable local electrical codes. The 180W continuous load rating requires circuit sizing at 125% of rated load per NEC continuous-load provisions.
• GFCI Requirement: Wet-area pump installations are subject to GFCI protection requirements under NEC Article 210 and applicable local amendments. Confirm GFCI requirements with a licensed electrician before installation.
• Water Quality Regulations: Operators in licensed cultivation facilities must ensure irrigation water sourcing, nutrient solution disposal, and drain-to-waste discharge comply with applicable state and local water quality and wastewater regulations.
• Facility Licensing: This product is sold for use in lawfully licensed cultivation and agricultural operations. Buyers are solely responsible for ensuring their facility holds all required state and local licenses and permits for the intended use.
• Shipping Jurisdiction: Available for shipment within the contiguous 48 United States only. No international or Canadian fulfillment is available through this channel.

Compliance requirements vary by state, county, and municipality. The information provided here is a general reference only and does not constitute legal or engineering advice. Cannafull Spectrum Solutions makes no representation that this product meets the specific regulatory requirements of any particular jurisdiction. Operators are responsible for confirming all applicable compliance obligations with qualified legal, electrical, and regulatory professionals before installation and operation.