Bomba de agua Vortex V-SYSTEM de Alien Hydroponics, 550 W, 120 V, 13 800 l/h

Quick Spec: 550W | 120V | 13,800 l/h flow rate | SKU: BD101-5008 | $380.00 USD

Precision Control in Any Space

The enemy is guesswork — and in a reservoir-fed system, guesswork compounds silently. An undersized or inconsistent pump doesn't announce its failure; it bleeds output gradually, creating uneven feed pressure across irrigation lines, starving distal sites while oversaturating proximal ones. The result is variance you can't see until it shows up in the canopy: uneven development, nutrient lockout in isolated zones, and the kind of inconsistency that forces manual correction on a schedule that was never supposed to exist. Every hour spent chasing flow problems is an hour not spent on the work that actually moves the operation forward.

After deployment, the irrigation circuit behaves like infrastructure — predictable, repeatable, and invisible in the best possible sense. Feed cycles run on schedule without pressure drop. Every site in the top-feed array receives the same volume at the same interval. The reservoir empties and refills on a rhythm the operator sets once and trusts indefinitely. Drain-to-waste runoff is consistent enough to use as a diagnostic tool rather than a variable to manage around. The system stops being something you monitor and becomes something you rely on.

The mechanism behind that reliability is straightforward: the V-SYSTEM Vortex pump draws 550 watts at 120V and moves 13,800 liters per hour — a flow rate sized for systems where volume and consistency are non-negotiable. The 550W power rating provides the hydraulic head pressure needed to maintain output across longer irrigation runs and multi-site top-feed configurations without the flow degradation that plagues lower-rated pumps operating near their ceiling. This is not a pump running at its limit; it is a pump with headroom. In practical terms, the V-SYSTEM Vortex delivers 13,800 l/h of continuous flow at 550W draw on a standard 120V circuit, providing the hydraulic reserve a multi-site irrigation system requires to run without variance.

Where This Belongs (and Doesn't)

Electrical circuit capacity and plumbing infrastructure must be verified by a qualified technician prior to installation. The V-SYSTEM Vortex Pump requires a dedicated 120V circuit rated for continuous 550W draw. Confirm reservoir volume, head height, and line diameter are compatible with 13,800 l/h output before commissioning.

How It Works

The V-SYSTEM Vortex pump operates on a vortex impeller design, which generates high-volume flow with lower mechanical resistance than standard centrifugal impeller configurations. This translates directly to sustained output under the back-pressure conditions common in multi-site irrigation runs — longer line lengths, elevation changes, and manifold splits that would cause a standard pump to drop measurably below its rated flow. The 550W motor provides the continuous power draw necessary to maintain 13,800 l/h without thermal throttling during extended feed cycles.

At 120V, the pump integrates directly into standard facility electrical infrastructure without requiring dedicated high-voltage circuits or step-down transformers. This simplifies installation in existing rooms and reduces commissioning time when adding irrigation capacity to an operational facility. The pump is designed for submersible operation within the reservoir, keeping the motor thermally managed by the water volume it is moving — a configuration that extends operational life compared to inline pumps exposed to ambient air temperatures in warm grow environments. In practical terms, the V-SYSTEM Vortex delivers 13,800 l/h of continuous, vortex-driven flow at 550W on a 120V circuit, with submersible motor cooling that supports extended duty cycles in active reservoir systems.

System Integration

• Reservoir Compatibility: Designed for submersible installation in open-top or sealed reservoir systems; confirm reservoir depth accommodates full pump submersion at rated operating level.
• Irrigation Line Sizing: Output volume of 13,800 l/h requires appropriately sized main feed lines and manifolds to prevent pressure buildup; consult line diameter specifications for your irrigation layout before connecting.
• Timer and Controller Integration: Pairs with standard irrigation timers and dosing controllers for automated feed-cycle management in top-feed and drain-to-waste configurations.
• Electrical Circuit Requirements: Requires a dedicated 120V circuit rated for continuous 550W draw; do not share the circuit with other high-draw equipment during pump operation.
• Inline Filtration: Installation of a pre-pump strainer or inline filter is recommended to protect the impeller from particulate matter in recirculating reservoir systems.

Facility Integration Data

The following ROI framework is provided to assist procurement decisions at scale; actual savings will vary based on facility layout, irrigation run frequency, and labor rates.

Operator Field Notes

• Prime before first run: Ensure the pump is fully submerged and the intake is clear of air pockets before powering on; running dry even briefly can damage the impeller seal.
• Monitor reservoir level: Set a minimum reservoir level alarm or float switch to prevent the pump from operating at reduced submersion depth, which degrades flow output and increases motor temperature.
• Inspect intake strainer weekly: In recirculating systems, root matter and nutrient precipitate accumulate at the intake; a blocked strainer is the most common cause of unexplained flow reduction.
• Match line diameter to output volume: Running 13,800 l/h through undersized feed lines creates back-pressure that reduces effective flow and stresses fittings; verify manifold and main line sizing before commissioning.
• Log flow rate at commissioning: Establish a baseline flow measurement at startup so any future degradation is detectable against a known reference rather than estimated by feel.
• Coordinate with irrigation controller timing: At 13,800 l/h, feed cycles fill and drain quickly; timer intervals set for lower-output pumps will likely need recalibration to avoid oversaturation in drain-to-waste configurations.

Shipping & Logistics

• Shipping Jurisdiction: Cannafull Spectrum Solutions ships within the contiguous 48 United States only. Orders outside this region cannot be fulfilled through this listing.
• Local Pickup: Available for in-person pickup at our Longmont location. Contact us to confirm stock availability before visiting.
• Returns: Returns are accepted in accordance with the Cannafull Spectrum Solutions Return Policy. Items must be in original, uninstalled condition. Contact our team to initiate a return authorization before shipping any unit back.
• Restocking Fee: Returns of non-defective items are subject to a restocking fee of up to 25% per our Return Policy. Review full terms at cannafullspec.com/pages/return-policy before ordering.

Questions about shipping, lead time, or order status? Contact Cannafull Spectrum Solutions directly before placing your order.

What's in the Box

• V-SYSTEM Vortex Water Pump 550W 120V (1 unit)

Note: Included accessories, fittings, strainer components, and documentation are not specified in available source data. Confirm complete box contents with Cannafull Spectrum Solutions prior to purchase if specific accessories are required for your installation. Do not assume compatibility with existing fittings without verifying outlet specifications.

Regional Compliance & Deployment Notes

• Electrical Code Compliance: Installation must comply with applicable local and national electrical codes. A dedicated 120V circuit rated for continuous 550W draw is required. Verify circuit capacity with a licensed electrician before installation.
• Plumbing and Water Use Regulations: Operators in licensed cultivation facilities should confirm that reservoir irrigation systems comply with applicable state water use, runoff containment, and facility licensing requirements in their jurisdiction.
• Licensed Facility Deployment: This product is deployed in licensed commercial cultivation facilities across the United States. Operators are responsible for ensuring equipment use complies with their state licensing authority's facility and equipment standards.
• No Canadian Distribution: This product is available through Cannafull Spectrum Solutions for delivery within the contiguous 48 United States only. Canadian orders are not fulfilled through this listing.
• Operator Responsibility: Cannafull Spectrum Solutions provides this product as an authorized dealer. Compliance with facility licensing, electrical permitting, and irrigation system regulations is the sole responsibility of the purchasing operator.

Regulatory requirements for irrigation equipment in licensed cultivation facilities vary by state and local jurisdiction. This page does not constitute legal or compliance advice. Consult your facility's compliance officer or licensing authority to confirm equipment deployment requirements in your operating jurisdiction before installation.